How to Rebuild a Cylinder Head
A cylinder head keeps oil from submerging and from running into the combustion chamber. A cylinder head houses the valves and the individual components that operate the valve train, such as lifters, camshaft, rocker arms, springs and rods. It is very critical to be as precise as possible when trying to rebuild a cylinder head. Most cylinder heads can be repaired and can be a very inexpensive process.
Tools Needed:
- Socket Valve Spring Needle-nose pliers
- Ratchet
- New oil seals
- Compressor
- New Oil Seals
- Solvent
- Gasket Scraper
- Brush
Instructions:
- Remove all of the old parts. In order to do this, you need a ratchet, socket, valve spring compressor and the needle-nose pliers. As you remove each part, separate and label them so that all parts are organized while doing the job.
- When all parts are taken out, the cylinder head must be cleaned. Clean the cylinder head from the old gasket material, the sludge and carbon buildup and anything else remaining on the cylinder head. Use the gasket scraper, solvent and wire brush to clean the cylinder head. If there is a lot of buildup in the cylinder head then take it to an auto body shop to have it cleaned.
- Inspect the cylinder head to make sure there are no visible cracks. Also, make sure the camshaft is still in good shape. The camshaft specifications are in vehicle service manual. It is crucial to make sure there are no damages in the cylinder head. Checking the cylinder head ensures no serious damage and to make sure a professional does not need to inspect the cylinder head.
- Put back all parts of the cylinder head the same way they were taken off. Use new oil seal to put together the cylinder head. Make sure everything is put back together the way in which they were taken off; otherwise, it will not work properly.