Previous Article

How to Rebuild a Cylinder Head

Next Article

How to Rebuild a Starter

How to Rebuild a Lawnmower Engine

Rebuilding a lawn mower engine will be difficult without the owner's manual.  The owner's manual will show the size of the engine and other parts needed.  Some basic mechanical skills and tools are needed.  Following these steps will help with the rebuilding process.

Items Needed:



  • Socket wrench

  • Screwdriver

  • Cylinder rings

  • Piston rings

  • Oil

  • Oil seals

  • Gaskets



  1. Take the engine apart.  Start by removing the engine cover.  Using a screwdriver or socket wrench take all the parts off the engine.  Clean each part with warm soapy water.  Make sure the parts are not to worn or damaged.  Some parts may be able to be reused.

  2. Examine all the parts.  Check the quality of the parts and decide if they are reusable.  Start the rebuilding process by torquing the head bolts then torque the rods.  The valves have to be lapped and set the clearance.

  3. Look at the cylinders to measure the size.  Make sure the cylinder is not larger than a standard size ring.  The ring will not seal.  Oversized rings can be purchased to fit the larger cylinder.

  4. Put the new gasket on.  It has to be put on correctly so the engine is completely sealed.

  5. Replace the spark plugs, air filter and oil filter.  Push the spark plugs tightly in place.  A loose spark plug will not allow the engine to work.

  6. Start the lawn mower.  Allow the engine to run for about 5 minutes with the throttle fully opened.  When everything is working properly, turn the engine off.  Let the engine cool down then change the oil.