How to Remove Metal Door Frames
If you are in the midst of replacing a door in your home or business and see that it is a metal doorframe there are two possibilities. One is that the doorframe is mounted with screws and the other that it is welded. There are two different ways of removing them.
Tools Needed:
- Drill and bits including screwdriver bits
- Reciprocating saw
- Hack saw
- Pry bar
- Hammer
Frames with Screws
- Remove the door. Take off the trim using the hammer or the pry bar.
- If the frame has screws remove them now. Be careful because the head is only held in place with jambs you just unscrewed. Do not let it fall on you while finishing.
- Take the jambs out and the head should just fall down. Do this carefully. If the jambs are really stuck in place use the hammer or the pry bar or both to get them loose.
- With frames that are screwed in you are now done.
Frames that are Welded
- Again you must remove the door and trim for access to the frame.
- Typically steel doors will be fastened with anchors of some type. Most of the time after removing the door and the casing you will see them. If not they are most likely at the bottom of the door. You may even have to remove some of the baseboard to find them.
- You can use the reciprocating saw or hack saw to cut them away from the frame. After the anchors removal you should be able to pry the base of the jambs away from the wall.
- This process will have to be repeated all the way up the jamb until all fasteners have been cut away from the jamb. Repeat this on the other side of the doors jamb.
- You will likely have to cut the jambs and the header into pieces to get it out. The easiest way is to cut both jambs and the header in half to remove them.
- If you find the bottom of the doorframe is attached to the floor you will have to cut it as well. You will have to repair or patch the floor or use a threshold strip to cover where it was damaged.