How to Remove Mineralization on Plumbing Parts
Hard water causes mineralization on plumbing parts and fixtures over time due to the buildup of calcium and lime. These deposits can build up causing unsightly stains on sinks, toilets and tubs. Over time this building-up can lead to decreased water pressure and drainage problems.
Items Needed
- 1 cup baking soda
- 1 cup vinegar
- Water
- Scrub brush
- Old toothbrush
- Bucket
- Sponge
- Mix baking soda and vinegar into a large cleaning bucket with 2 gallons of water.
- Agitate the water until the vinegar and baking soda are thoroughly mixed with the water.
- Place a scrub brush into the bucket, then pick up and allow the excess water to drain off.
- Scrub down external areas that you can reach with the scrub brush, such as sinks, toilets and tubs.
- Rinse all areas thoroughly with clean water.
- Remove any plumbing that you cannot easily reach and place the pieces into the bucket of cleaning solution that you have made.
- Allow the plumbing pieces to sit in the solution for approximately 15 minutes to loosen the mineral build-up.
- Scrub down each plumbing pieces individually to remove any mineral deposits that remain using a textured sponge. Use the old toothbrush to reach inside of the plumbing pieces.
- Replace the parts into the solution and allow them to sit until any remaining mineral deposits have been removed.
- Rinse all of the pieces thoroughly with cold water, removing the cleaning solution and loose particles.
- Replace all of the parts that have been removed back where they belong and ensure that they are thoroughly tightened.