How to Separate Plumbing Parts
It is possible to reuse piping if you can properly separate the sections. With the exception of the couplings, keeping the parts will be helpful when repairs or changes are needed. When dealing with pipes containing frozen water, the pipes must first be warmed enough to turn the ice back to liquid.
Plumbing lines are either plastic or copper. With the exception of joint pierces, both
copper and plastic piping can be reused. While solder can be softened to release its hold, there is no solvent to remove the glue used on plastic piping.
To melt the ice inside piping, use a heat lamp or hair dryer. When using a heat lamp, keep it about 8 inches from the pipe.
Separating Copper Piping
Tools Needed:
- Propane torch
- Water-pump pliers
- Turn on the propane torch.
- Heat the soldered joint until it becomes shiny and melts.
- Use water-pump pliers to pull the pipe and coupling apart.
Cutting Copper Piping
Tools Needed:
- Tubing cutter
- Marker pen
- Mark the copper pipe where it will need to be cut. When removing a coupling, the mark should be 2 inches from either side of the coupling.
- Place the tubing cutter around the pipe.
- Rotate the tubing cutter fully around after tightening it on one of the marks.
- Tighten and rotate the tubing cutter repeatedly until the pipe is cut.
- Repeat the above two steps on the other mark.
- Discard the coupling.
Separating Plastic Piping
Tools Needed:
- Marker pen
- Hacksaw
- Pipe cutter
- Mark 4 inches from either side of the coupling on the plastic pipe.
- Use a hacksaw or pipe cutter to cut through the pipe at each mark.
- Discard the coupling.