How to Remove Vinyl Siding and Restore Wood Siding
Contrary to what many believe, vinyl siding can get grungy looking or faded and become quite unattractive. If it was applied over wood siding to begin with you may be able to restore it back to the original siding. Word of caution, you may not like what you find under the vinyl siding.
- Buy a zip tool at your local home improvement center or hardware store. These are specially made to remove siding and only cost in the vicinity of $5. You can have a look at the wood under the siding if you wish to see its condition prior to taking the siding off. You may have to replace the wood if it is in bad shape and then you may be rethinking the siding.
- Start at the top of your siding to remove as panels are connected the panels above. You have to unlatch the top panel to remove the one below.
- Place the zip tool under the lower corner of a panel and with a curved motion find the notch behind the panel. After hooking the tool in the notch slide it horizontally and pull down releasing the panel. Go to the other end of the panel and do the same procedure. With a claw hammer remove the nails holding the panel to the house. Remove the panel.
- Restore the wood underneath with procedures normally recommended to restore whatever type of wood is there. If the wood is painted check to see if it needs repainting. If it is stained and not faded clean as you normally would clean it. Should there be mildew or mold problem mix your cleaning solution with a one quarter bleach per three quarters water solution and some dish soap. Scrub those areas down well.
- Fill in any holes or replace and caulking missing from joints if necessary. These are minor problems and can all be fixed inexpensively.
- Paint the wood or siding if necessary. Paint as normal providing you have corrected any flaws in the wood first.