Previous Article

How to Repair a Hole in Bath Tub

Next Article

How To Repair a Hole on the Bottom of a Pool Liner

How to Repair a Hole in Fiberglass Bathtubs

There are many benefits to using a fiberglass bathtub. Not only it is easy to install but also it is lighter than other types of tubs, especially the iron tub. They are manufactured as one piece, which makes it easier to maintain. The only disadvantage with the fiberglass bathtub is that it is not as strong as other types, which causes holes. The holes can be fixed easily and inexpensively using the proper method.

Materials Needed



  • Fiberglass patches

  • 60, 200, 400 grit sandpaper

  • Scissors

  • Rag

  • Fiberglass hardener

  • Fiberglass resin

  • Putty knife

  • Marine plastic filler

  • Gel coast

  • Paintbrush

  • Plastic wrapping


1. Sand the hole with 60-grit sandpaper. This will prepare the area for the patch. Make sure you sand 2 inches outside of the hole.


2. Carefully read the instructions for the fiberglass patch products, which you can purchase at your local home improvement or hardware store.


3. Use scissors to cut the cloth in the package into three separate patches. The first patch should be slightly larger than the hole. The second and third patch should be progressively smaller than the first patch.


3. Mix the fiberglass hardener and resin according to the instruction on the package.


4. Put the three patches in the hardener and resin mixture. Allow the mixture to saturate the cloth.


5. Take the smallest patch and place it over the hole. Follow this patch with the medium patch. The largest patch should be placed last. Allow the patches to set over the hole for eight hours.


6. When the patches have completely dried, use 60-grit sandpaper to sand the area. Use a damp cloth to wipe away any remaining sandpaper residue.


7. Use a putty knife to evenly spread marine plastic filler on top of the patches. Allow the area to dry according to the direction on the package.


8. Use 60-grit sandpaper to and the outside edges of the marine plastic filler. Use a damp cloth to clean the area.


9. Apply a layer of gel coat over the plastic filler using a paintbrush. The gel coat should be 1/8 inch thick. Cover the gel coat with plastic wrapping and allow it to set for 24 hours.


10. Sand the gel coat and plastic wrapping with 200-grit sandpaper. Use a damp cloth to wipe the area. Use 400-grit sandpaper to sand the area.  This will blend the patch into the surface of the tub.