Previous Article

How to Repair a Patio Swing

Next Article

How to Repair Camper Water Damage

How to Repair a Sinking Brick Patio Set in Sand

Many brick patios are built on top of sand. During the year, the weather causes the ground to freeze or thaw. The ground expands and contracts. The patio starts to sink a tiny bit. Another cause of the patio sinking is the mortar that chips and cracks. Sand can not support brick patios alone. It must have a layer of crushed stone. 

Things You Will Need



  • Square tamper

  • Chisel

  • Ruler 

  • Mortar

  • Cement

  • Fine sand

  • Sand or gravel

  • Water

  • Brick trowel

  • Pointing trowel

  • Broom

  • Pressure washer

  • Grout bag 

  • Rectangular scrap of wood

  • Wheelbarrow


Rebuild the Bricks of the Patio with the Mortar Base



  1. Use a chisel to remove the sinking bricks. Remove all the old mortar that is stuck to the bricks and around the level bricks that neighbored the bricks you just removed. 

  2. Mix three parts sand and one part cement in a wheelbarrow. Add water and mix. Continue adding until it becomes a muddy mixture. Lay mortar into the spot where the brick was removed. The layer should be 1/2-inch thick. 

  3. Level the mortar with the scrap piece of wood.

  4. Apply mortar to the sides of the brick, using the pointing trowel. The layers should be 3/4-inch thick.

  5. Place the brick into its vacant spot, closely together to its neighboring bricks. 

  6. Apply mortar between the reapplied brick and its neighbors, using the pointing trowel. 

  7. Sweep the excess mortar lying on top of the bricks, using a broom.


Replacing the Bricks of the Patio Without the Mortar Base



  1. Remove the bricks, using a chisel. 

  2. Fill the vacant space with sand or gravel. 

  3. Level and flatten the sand or gravel, using the square tamper.  You may have to repeat if you need more sand or gravel to make the new or old brick level with its neighboring bricks.

  4. Place all the bricks back into their vacated spots. 

  5. Sprinkle sand all over the bricks. The layer should be 1/2-inch thick.

  6. Sweep the sand into the cracks, using the broom.