How to Replace Outboard Motors
If you use you use your boat for more than one thing, you may need to use more than one engine. When you're feeling the need for speed, you'll need 300 horsepower. When you just want to cruise, a 40 horsepower motor will work just fine. Changing stands between the two will take some general knowledge about your boat and a few hours.
What You'll Need:
- A-frame
- Chain fall
- Wrench
- Move the empty motor stand that will eventually hold the outboard that you plan to remove to the center rear area of the boat. Move the motor stand that holds the motor that you plan to install to the rear of the boat and position it next to the empty motor stand.
- Connect the top block of the stationary block of your chain fall to the cross bar of the automotive repair A-frame that you previously used to move your outboard to its storage stand. Move the A-frame so that it is placed directly on top of the motor of your boat.
- Remove each of the mechanical connections and the electrical connections from the motor abroad your boat. Take off the hoods of both outboards. Lower the hook on the movable block of the chain fall to the lifting ring on top of the motor of your boat. Then, remove the motor mounting bolts from the transom of the boat and raise the motor clear of the transom. Move the boat slightly forward and ensure that it is no longer beneath the motor that you just removed.
- Take the empty motor stand and move it just under the motor that you previously removed from your boat. Lower the motor onto the motor stand and secure it with mounting bolts. Move the motor stand away from the boat.
- Move the new motor to the center rear area of the boat's transom. You can do so by pushing the motor stand to the center rear of the boat's transom. Connect the empty chain fall to the motor you plan to install by hooking the chain fall to the lifting ring on the motor. Lift the motor with a chain fall and move the empty motor stand from the rear of the boat.
- Move the boat to allow the transom to be directly under the motor mount. Begin lowering the motor. Install each of the mounting bolts in the transom by using a wrench to do so. Connect the required mechanical and electrical connections to the motor you just mounted.