How to Replace Roof Trusses With Stick Framing
During the construction phase of your home, the contractor may have installed trusses onto the frame of the roof. These roof tresses are custom-engineered to fit your house's specific design. Which depending on the design may have prevented you from having a vaulting ceiling or to finish out an attic space.
What You'll Need:
- Engineered plans
- Support beams
- Dimensional lumber
- Carpenter's hand and power tools
- Contract the services of an engineer to help you re-design your roof's load-bearing structure before removing any trusses. The roof truss will bear the bulk of the weight of the roof and transfers that weight onto the sidewalls of your home. Before you begin to cut away any trusses, you’ll want to alternate load-bearing measures.
- You’ll need to run a support header just underneath the ridge of your roof; it should span the length of your roof. The supports headers can be steel I-beams or dimensional wood timbers. The engineer you hire will determine what type of header is best suited based on the distance of your roof span as well as the configuration of your roof.
- Decide on a plan for constructing support walls or beams. After you have cut the roof trusses, the weight of the roof will then shift to the new supports. For proper support, each end of the ridge header will need to rest upon a support that runs al the way down to the concrete footer that located underneath your foundation. Keep in mind you may need to add additional supports in the middle of the house. You may disguise the new supports from inside the walls.
- To reinforce the roof rafters you’ll need to run additional rafters from the new support header all the way to the sidewalls. This step is one of the most essential due to the fact that the lumber you use to support the roof decking and the shingles is a component of each roof truss section. When any parts of the trusses are gone, the truss rafters can lose some of their ability to support the sides of the roof.
- Both cut and remove the trusses after the new support system has been put into place. Then remove the original trusses and open the attic space. You’ll only need to do this if you plan to use the attic for living space. Ensure that you install stronger floor joists than those that you used in the original roof trusses.