Previous Article

How to Reupholster a Metal Bar Stool

Next Article

How to Set Tropical Decor for Living Room Furniture

How to Revamp an Old Bar Stool

Revamping an old bar stool can make it look like new again. The tools to use depend on the type of bar stool the owner needs to fix up. For a stool with metal legs, the owner will need some paint. For a wooden stool the owner needs sandpaper and some wood stain.

Items Needed:



  • Cleaning supplies

  • Rust remover (if applicable)

  • Screwdriver

  • Sandpaper (if applicable)

  • Paint (if applicable)

  • Wood stain (if applicable)

  • Foot pads



  1. Clean your old bar stool with some soap and water. Inspect the seat and legs to see what type of condition they are in. If you have a wooden bar stool you may need to sand the legs if they are rough. If your bar stool is made of metal, you may need to remove some rust.

  2. Unscrew the seat with a screwdriver and put it off to the side. Sand the barstool legs if they are made of wood and check them to make sure they are smooth. If you want to improve the appearance of the legs you can use some wood stain on the barstool.

  3. Apply rust remover to metal barstool legs. Read the instructions on the container to determine how to use the rust remover. Paint the legs after the rust remover dries to make your barstool look like new.

  4. Inspect the barstool seat to see if it is in good condition. If you decide to replace the seat you should be able to find one online. Measure the seat so you know the right size to buy.

  5. Attach the old seat or wait for the new one to arrive. Once your seat is on make sure that you test the bar stool before anyone sits on it. Check the bottom of the legs to see if you need to apply foot pads so the barstool will not scratch your floor. Buy the pads at a hardware store and cut them to the right size to finish revamping your barstool.