Previous Article

How to Sharpen Knives

Next Article

How to Shelve Library Books

How to Sharpen Mower Blades

Dull lawn mower blades deliver cuts that are not only unsightly but detrimental to your lawn's overall health. For this reason, blades should be sharpened at least once every two weeks to keep them in top condition. The best time to do this is when performing regular weekly user maintenance.

Step One - Disconnect the spark-plug wire from the lawn mower. This is important so the unit does not accidentally start.



Step Two - Carefully raise the mower deck and remove the blades with a wrench.



Step Three - Visually inspect the blades to determine their condition. Blades that are free of nicks and curls can be sharpened with a file. Blades that are badly damaged with dings and pits will require a bit more aggressive maintenance with an electric grinder.



Step Four - For a blade in good condition, clamp it in a vice on a workbench and run a metal file along the sharp edge of the blade. Be careful to follow the angle of the factory bevel on the blade. Continue filing until sharp.



Step Five - For blade's that are damaged and have visible pits or chips, they must be sharpened with a grinder to remove these areas. Turn on the grinder and run the damaged edge of the blade back and forth perpendicular to the spinning grinding wheel. This will create a flat blunt edge free from dings and pits. Do this along the entire length of the blade. Rest the blade on the grinder's plate and grind at an angle until a sharp edge is achieved along the entire length of the blade. If the blade has deep pits or is cracked it must be replaced rather than sharpened for safety reasons.



Step Six - Check to make sure the blade is balanced properly. This can be done with a plastic balancer available at most lawn and garden centers. If the blade is unbalanced and dips, a bit of steel must be ground from that end of the blade's non cutting edge until a balance is achieved. This should be done with the grinder.



Step Seven- When the blade is balanced, reinstall it back to the bottom of the mower deck.



Step Eight - Reinstall the spark plug and make a test run with the mower to check the blade's performance.