How to Snake Drain Lines
Clogged sinks require immediate attention. For a homeowner with a bit of plumbing knowledge, it is a less expensive to try cleaning the drain lines yourself with a plumbing snake before calling the plumber. Before attempting to unplug the drain make sure you have the correct equipment for the job.
Supplies
- Drain Snake
- Old towel
- Check the length of your drain snake. They come in a variety of lengths and diameters. Your snake must be long enough to reach from the clogged drain location all the way through the branch line to the house's main drain line. Generally, 50 foot snakes are adequate. It is important to verify the length to maximize success in your battle with the clog.
- Remove any standing water from the sink. This can be done by either bailing or using a rubber plunger to force out as much as possible.
- Remove the drain cover.
- Unloosen the set screw on the auger housing and manually pull out about ten feet of cable. Retighten the screw.
- Introduce the auger end of the plumbing snake into the drain pipe.
- Push or crank the drain auger in a clockwise motion slowly down the drain and around any bends.
- When you feel resistance and can no longer advance the auger you have reached the clog.
- Crank the auger clockwise with steady and even pressure to chew deep into the clog. Try and trap the clog debris on the end of the auger.
- Once the auger moves freely forward it's time to remove it. Crank the auger counterclockwise to back it out of the drain.
- Wipe the cable off with an old towel as it is comes from the drain.
- Once out of the drain grab the debris and discard.
- Flush the drain with hot water for three to five minutes.