Previous Article

How to Stretch Barbed Wire Fencing

Next Article

How to Strip Paint Off of Wrought Iron Railing

How to Strip Metal Railings

Metal railings, especially outside are constantly exposed to all type of whether conditions. Eventually the railings will begin to fade, peel, rust, or chip, and when it starts looking bad the metal railing needs to be stripped to be repainted. It does take a little work to strip metal railings, but once it is done it makes it so much easier to repair the railings.

Things you'll need:



  • Poly abrasive disc attachment

  • Power drill

  • Wire brush

  • Sanding disk attachment

  • Sandpaper

  • Mineral spirits

  • Vacuum

  • Rags



  1. Place the poly abrasive disc into the power drill end, and then tighten the chuck. A poly abrasive disc actually looks like a sponge that is covered by glue and sand.

  2. Start the power gun by pressing the trigger, and using a circular motion, run the disc offer the railing. Continue to do this until you have removed a good amount of rust and old paint. 

  3. Scrub areas that you cannot reach with the poly abrasive disc by using a wire brush.

  4. Take a sanding disc attachment and replace it for the poly abrasive disc.

  5. Smooth out the rough areas by running the sanding disc over the railing. This helps to remove any remaining rust or paint.

  6. Take regular sandpaper and use it to smooth out any areas that you are unable to reach with the sanding disc.

  7. Dampen a rag and add mineral spirits to it, and then wipe along the railing with the rag. Any dust or paint residue that resulted from sanding can be removed using this rag.

  8. Use a small vacuum or vacuum attachment to clean of any dirt, debris, or paint chips from off the ground around the railing.