How to Thread a Sewing Machine
If you are a beginner when it comes to a sewing machine, knowing how to thread a sewing machine is key to mastering one. For this specific project, it is best to have a list than to have someone explain it to you. If it is explained to you, the steps will seem very overwhelming. It will take a little longer to do at first but after you've mastered it, it will only take a few seconds.
1. Turn the handwheel toward you. This will raise the needle to its highest position.
2. Raise the pressor foot. By doing so, the thread will easily pass through the threading points. It will also prevent the needle from becoming unthreaded while stitching.
3. Place a spool of thread on the spool pin; this should be located on the top or your machine.
4. Take the thread end and run it through the designanted threading points. Then run it down the towards the tension assembly which is located on the left side of the machine and controls the the floe of thread.
5. Take the thread under the tension assembly and back up through the next threading point at the top left of the machine.
6. Push the thread end through the lever at the top left of the machine and down through the threading points at bottom left and above the needle.
7. Thread the needle from the front of the needle to the back.
8. Pull a few inches of thread through the needle and pull it to your left.
9. Insert a wound bobbin into the machine and close the throat plate if necessary. Pull a few inches of bobbin thread through the bobbin, pull it to the right and then it should be sticking out from under the closed throat plate.
10. Hold the thread that has been threaded through the machine needle. Rotate the handwheel until the needle disappears into the bobbin case.
11. Move the handwheel until the needle is at its highest point again and hold the thread while doing so. As it rises, a loop of bobbin thread will come up as well.
12. Pull the thread out to your left to draw the bobbin thread further out of the bobbin case.
13. Let the top thread go and pull the bobbin thread until the end comes up. Pull the top and bottom threads under the presser foot and to the back and right of the machine.