How to Troubleshoot a Subaru Tribeca
If you are having problems with your Subaru Tribeca, there are some troubleshooting steps you can take to try to determine what the problem is. You can use the owner’s guide of your vehicle to start the troubleshooting process, and in some cases will be able to fix the problem yourself.
- Check the battery on your Subaru Tribeca. Look at the cable connections and make sure they are not loose. Tighten them up if they are. Look for any corrosion that may have built up on the battery. If you see corrosion built up, clean it off by mixing together half baking soda and half water and placing it on the terminals. The paste will start to bubble and remove the corrosion. When it is finished, remove it with water. Dry it off with a micro fiber towel.
- Check the pressure on the tires using a tire pressure gauge. If the pounds per square inch (psi) is below 27, the Subaru Tribeca will show a low pressure warning on the display on the dashboard, but you will still not know how much air the tire needs. Running a car with low tires can cause your car to get bad gas mileage. Add air to the tires with an air compressor for the recommended pounds per square inch.
- Check the brake pads on your Subaru Tribeca if you are having problems with them. Remove the wheel from the car, loosen the mounting bolts, and remove the mounting unit to show the brake pads. If the brake pads are bad, they should be replaced immediately.
- Look at the belts and hoses under the hood. Turn the car on and allow it turn run while you look for leaks or bulges in the hoses that connect to the engine. Turn the car off, and look for cracks or weak spots in the belts. If you see problems, contact a Subaru dealership for repair.