Previous Article

How to Ride With a Bitless Bridle

Next Article

Instructions on Using a Bitless Bridle

How to Use a Bitless Bridle

Traditional horse bridles have a bit, a metal piece that goes in the horse’s mouth and is attached to leather straps which fit over the horse’s ears on both sides. Horses sometimes balk at, or even develop health problems due to the use of a bit. A bitless bridle is a pain free alternative to the bit. It fits around the nose and uses gentle pressure underneath the jaw to control the horse.


  1. Prepare the bitless bridle for use on your horse. Unbuckle the chinstrap on the bitless bridle, leaving all other straps buckled.

  2. Spread the noseband open and put the bridle over the horse’s head. Fitting the bridle over the horse’s ears, make sure the straps are properly fitted under its jaw and over its nose.

  3. Adjust the straps on the left and right side of the bridle using the cavesson buckles. The lower edge of the noseband should sit about 2 inches above the corner of your horses mouth.

  4. Adjust the buckles found on the left and right side of the strap that crosses under your horses jaw. There should be 3-inches of the strap between the rings on each side of the noseband and the rings on each side of the reigns.

  5. Tighten the chinstrap buckle to where one finger can fit between the strap and your horses jaw.

  6. Give the bitless bridle a try. Creating tension by pulling the left side of the reign with cause the ring on the right side of the bridle to gently push your horse to the left, and visa versa.

  7. Make your first few rides with the bitless bridle short ones, preferably in a small area like the barn or horses paddock. Your horse won’t be used to the feeling of freedom from the bit, and may be more high-spirited than normal.