Previous Article

Inpatient Alcohol Rehabilitation Programs

Next Article

Installing a New Car Battery

Installation Instructions for Automatic Gate Openers

An automatic gate opener provides extra security for entrance to private property. It also allows you to stay in your vehicle on rainy or other days with inclement weather. Having an automatic gate opener also provides easier entry into your home if you have difficulty getting in and out of your vehicle. It is an added feature with little cost to install.

Once the gate is in place, the automatic gate opener can be installed, which will open the gate by a remote device.


Installation instructions for automatic gate openers:



  1. Drill holes for adding the gate control box, which opens the gate.

  2. When mounting the control board, take caution that the gate opens and the gate is fully functional.

  3. Bury the sensor on the property side of the gate. It should be buried one foot into the ground, and approximately fifty feet away from the gate. Make sure that the exit sensor is buried in a trench, with a wire connecting it to the gate control box.

  4. Connect the wiring that runs along the keypad, the exit sensor, and the power source. They should all be connected to the control box. Make sure that the control arm is connected directly to the control box.

  5. Install the keypad, if you have one.

  6. Make sure that all of the wires are connected to the control box, which should be mounted in a fixed position near the hinge post for the gate. It should be connected to a battery, charged by an electric line or solar panel device.