Installing Electrical Outlets and Fixtures
If you have basic electrical knowledge, installing your electric light fixtures and outlets can save you bunches of money. But make sure you follow safety procedures, because electricity can be deadly if mishandled. Updating your light fixtures and keeping your electrical outlets in good condition adds value to your home.
Light fixtures
Updating light fixtures to a more modern design, or because they no longer work will only take you about one or two hours. Remember to turn off the power at the circuit breaker before you start trying to install any fixtures. You can cut power to the room you are working in, or you can cut power to the entire house. Light fixtures are attached to a junction box in the ceiling, and depending on the type of light fixture you install, you may need to cut the hole in the ceiling larger or add ceiling joists to hold a larger unit. You can research specific types of lights and requirements at a magnitude of different websites and blogs. In general, the wires will be color coded and you will attach like colors together. Add wire nuts to cover splices and use bulbs that meet the UL rating of the fixture. The UL rating is the maximum wattage the light fixture can handle without a fire risk.
Electrical Outlets
Installing electrical outlets in your home doesn’t need to be done by a licensed electrician. You can safely install them yourself. Remember to shut off the power to the room you are working in at the breaker box. Use a circuit tester to ensure the electricity is off. Measure from your electrical panel to where you want to install an electric outlet, this is how much wire you need. Add an extra 30 to 50 cm of wire in order to have a little extra to work with. The amperage and voltage of the wire needs to match that of the circuit. The wire will have three color coded ends. Uncover the electrical panel. Run the wire through the floor or the ceiling, starting at the electrical panel and using an existing hole. Run wire to your new outlet after you have cut the space for your electrical outlet. Hook up the color coded wires to the electrical outlet, starting with the green grounding wire. Screw the outlet in place in your new box. Install the cover and turn your circuit breaker back on. Check the power in your new outlet. Put the cover back up on your electric panel.