Process for Fixing an Alternator
If you want to save yourself some hard earned cash, you can rebuild your alternator instead of replacing it. Fixing an alternator takes some time and patience. You must remove, disassemble, repair, reassemble and reinstall the alternator into your vehicle.
Removing the Alternator
1. Make sure your vehicle's engine is cool.
2. Disconnect the negative cable to your vehicle's battery. You don't want to shock yourself.
3. Next, remove the serpentine belt that is located on the pulley of the alternator. You will have to loosen the tensioner so the belt with become loose enough to remove. Use a socket wrench to loosen the tensioner.
4. Locate the mounting bolts on the alternator. Using a socket wrench, remove the bolts. Do not lose the bolts; you will need them to fasten the new alternator to your engine.
5. Disconnect all the wires from the alternator, noting where each wire was connected. Your alternator will then be free to remove from the vehicle.
Disassembling the Alternator
1. Start by removing the voltage regulator, it will be located on the back of the alternator and looks like a small button. Remove the nuts and bolts that are holding it in place.
2. Remove the worn brushes. Do not lose the push springs, you will need those again. Replace the brushes one at a time. You can use a toothpick to hold the brushes in place.
3. Reattach the voltage regulator to the alternator. Make sure your remove the tooth picks after the regulator is in place.
Installing the Alternator
6. Attach the new alternator using the bolts from the old alternator.
7. Attach the wires to the new alternator in the correct location.
8. Now its time to attach the serpentine belt. Loosen the tensioner so you can place the belt on easily. Once the belt is in place, tighten the tensioner so that the belt is secure. Do not over tighten.
9. Replace the negative batter cable on your battery.