Previous Article

Steps for Repairing Plumbing in a Recreational Vehicle

Next Article

Steps for Soldering Alternator Brushes

Steps for Replacing Alternator Bearings

Alternators provide charges for the battery to prevent the battery from dying under normal driving conditions. They are located on the lower right side of the engine compartment. When the alternator bearings inside the alternator go bad, there is a whining sound. This article will cover the steps for replacing alternator bearings.

Steps For Replacing Alternator Bearings




  1. Remove the bolts from the alternator.


  2. Heat the rear bearing to 130 degrees with a hair dryer.


  3. Mark the housing halves using a screwdriver.


  4. Clamp the rotor in a vice and remove the pulley nuts. Remove the rear rotor bearings with a pulley.


  5. Use a hand press to install the new bearings.


  6. Remove the front bearing retainer plate and drive it out with a punch and hammer.


  7. Drive the new front bearings into the housing with a hammer.


  8. Reinstall the front bearing plate and front pulley nut and torque them to 80 foot pounds.


  9. Reassemble the two halves and reinsert the bolts. Rotate the alternator.