Previous Article

Steps for Replacing Alternator Bearings

Next Article

Steps for Successful Compost Gardening

Steps for Soldering Alternator Brushes

When you install new wires and brushes on an alternator, you have to re-solder both the wires and the brushes. This task is similar to rebuilding an alternator in that you are repairing components. By repairing the components instead of buying a new alternator, you save a considerable amount of money.

Steps for Soldering Alternator Brushes:



Step 1: Disconnect the battery cables. Detach the battery cables from the alternator. Remove the retaining bolt from the back of the charging unit.



Step 2: Remove the alternator. Remove the alternator's tension bolt. Remove the alternator belt. Unscrew the alternator's mounting bolt, and carefully pull the alternator out. Place the alternator on a clean worktable.



Step 3: Remove the alternator cover. Remove the voltage regulator. Remove the brush assembly and the assembly cover. Keep the brushes and springs in place.



Step 4: Remove the old solder from the old brushes. Slide the springs onto the new brushes.



Step 5: Place electrical tape around the assembly. This will hold the new brushes in place, so you can solder the new wires.



Step 6: Solder each new wire one at a time. Allow the solder to dry completely.



Step 7: Reattach the rubber cap. Reinstall the voltage regular and the brush assembly.



Step 8: Reinstall the alternator cover. Reattach the alternator's mounting bolt. Reinstall the retaining bolt to the back of the charging unit.



Step 9: Reattach the battery cable to the alternator. Reconnect the battery cables.