Previous Article

Steps to Repair a Small Engine

Next Article

Steps to Repair a Timing Belt

steps to Repair a Sticky Ignition Switch in a Truck

It is not unusual for an ignition switch in a truck to stick over time. It is mainly due to the pins in the tumbler jamming up. It is not necessary to replace the ignition switch when this happens. It can easily be repaired by lubricating the switch.

Steps to Repair a Sticky Ignition Switch in a Truck




  1. Spray a generous amount of WD-40 into the keyhole of the ignition switch of the truck. WD-40 is fairly inexpensive and can be purchased at any auto parts store, such as Pepboys or O'Reilly's Auto Parts.


  2. Insert the truck key into the ignition switch and pull it in and out several times. By doing this, the lubricant gets spread throughout the switch.


  3. If the key is still sticking, repeat the above steps until the switch will turn easily.


  4. Use an old rag to wipe away the excess lubricant from the switch and the ignition key.