DIY Wiring for Wall Lights
Installing wall lights in your home yourself is an easy and inexpensive process. Taking extra precautions with electricity, having the necessary materials, required tools and following the manufacturer’s directions will ensure your wall lights are safely and properly installed without the help of a professional.
Electricity can be dangerous and even deadly, but it is an easy concept to understand in terms of do-it-yourself wiring. The electricity enters your home at the breaker box. From there, wires take it to all of the outlets, switches and ceiling fixtures in your home. When a light is on, a circuit is completed, electricity is flowing and your light or appliance is powered. When you turn a switch off, the circuit is broken and the electricity can no longer flow. To install a wall light, you will simple be adding another circuit with wiring, a switch and a light.
- Make sure that the power is switched off at the breaker box. If you are not sure which switch controls the electricity in the room where your wall light is being installed, turn on a lamp in that room, and then flick each switch to the off position, one at a time, until your lamp shuts off. Do not turn the switch in the breaker box back to the ‘on’ position until the wall light is completely installed.
- Use a voltage meter to check that the wiring you will be working with truly has no electricity running through it. There is always the chance that lines have crossed or that someone else has incorrectly wired the connections, etc. A voltage meter can be purchased at any home improvement store for under $10. Most models light up if they come close to an electric current. Always test the voltage meter first on a known “live” wire before relying on it.
- More than likely you will need to cut into your wall to gain access to an outlet or switch’s electrical box. Because the wiring for your new wall light will connect to the existing wire at the electrical box, you might have to cut a hole in the wall to run the wire through. Cutting into drywall requires a utility knife or saw, and it is a very dusty job. Use drop cloths and a facemask to protect yourself and your furniture. Also, have on hand the necessary materials to patch the hole once your wall light is installed and tested.
- Follow the installation directions that came with your wall light. You will possibly need additional materials such as extra wire, an electrical box, a switch, a screwdriver or drill, wire cutters, and electrical caps.
- Test your installed lighting first before patching your drywall or putting away your tools. Shut the light off, turn the breaker switch back to the ‘on’ position, and make sure your light will switch on. It is a hard lesson to learn when a patched wall has to be re-cut because a wall light was not installed properly.