Previous Article

How to Put Transmission Fluid in an Acura Legend

Next Article

About the Acura MDX

How to Assemble an Acura MDX Headlight

If the headlights on your Acura MDX have been broken or scratched, you'll need to replace them. Doing so is fairly simple due to the design of the front end of the Acura MDX. Unlike many vehicles, the nearby engine compartment parts don't have to be removed in order to do so.

What You'll Need:



  • Painters tape

  • Socket wrench set

  • Manufacture vehicle manual



  1. Turn on your Acura MDX. Refer to the manufacture vehicle manual to locate your hood release button. Once located press the button to unlatch the hood and open it. Ensure that the hood is placed in the proper socket and is secure before leaning up under it to ensure safety.

  2. Once under the hood, remove both of the long bolts that run vertically through the headlight housing area, known as the headlight assembly. You'll also need to remove the rear bolt that is mounting the headlight to the headlight bracket.

  3. Locate the two wire harnesses and disconnect them from the rear of the headlight assembly.

  4. Once the wires have been completely disconnected, pull out the headlight assembly on your Acura MDX.

  5. You'll need to remove all of the working headlights from the old headlight assembly before discarding it as they can be used again with your replacement assembly. Take the working components and position them into the specified sockets within the new replacement headlight assembly.

  6. Lastly, insert the replacement headlight assembly on top of the bracket. Ensure that it is secure by replacing the three bolts that were removed earlier and reattach the wiring harness.