Previous Article

How to Calculate Fabric in Order to Sew Window Valances

Next Article

How to Make Unusual Window Valances

How to Create Your Own Window Valances

Window valances are a decorative compliment to the backdrop of a window. Typically, valances are fabric coverings that are connected to the top part of the window in order to hide any hardware underneath. If you're in need of new valances, you can avoid the in-store mark up and make them yourself.

What You'll Need:



  • Valance board

  • Measuring tape

  • Drapery fabric

  • Scissors

  • Hook and loop fastener strips

  • Hot-glue gun

  • Hot-glue strips

  • No-new hem tape

  • Sewing machine

  • Thread

  • (2) 1 inch screws

  • Electric drill



  1. Use your measuring tape to measure the valance board. You'll need to complete this step in order to establish the amount of fabric you'll need to cut in order to create the valance. Consider adding 1 inch to each side of your measurement to allow for the hem.

  2. Cut the fabric for the valance carefully following the measurements you previously took.

  3. Cut one strip of the hook and loop fastener to the exact same length as the valance board. Use a hot glue gun to attach the fastener completely around the upper edge of the valance board.

  4. Hem both the top and bottom of the valance. You can complete this step by folding the edge of the fabric along the no-sew hem tape, and then iron it in order to create a crease. Remove the back from the tape and re-fold the crease over top the "sticky" part and smooth it down to complete the hem. Repeat this process for each of the hems. Use a iron on the valances to remove any wrinkles.

  5. Pin any remaining strips of the hook and loop faster to the upper edge of the valance fabric. Stitch the center of the strip using a sewing machine to ensure that it is secure.

  6. Connect the valance to the valance board on the hook and loop fastener strip. You'll need to attach the valance board angle hardware to the area on the wall just above the window using at least one screw on each end.