How to Fix Turn Signals on a Saturn SL2
When the turn signals go out on your car they will need to be changed as soon as possible to avoid getting a ticket and due to it being a safety issue. The issues that may affect why your turn signal may not be working could be due to wiring, broken fuses or burned-out bulbs.
Tools Needed
- Socket wrench
- Replacement bulb
- Replacement fuse
- Clean rug
- Flat-tip screwdriver
How to Fix Turn Signals on a Saturn SL2
- Open the hood after turning off the engine. Use the screwdriver when removing the push-pin fasteners. The push-pin fasteners are located in the grill assembly.
- To remove the assembly, tilt it forward and remove it from the car with a socket wrench.
- Disengage the assembly and plug the electrical connector into the back of the assembly. You should be able to see it once you lift up the headlamp housing.
- Rotate the turn signal bulb socket counterclockwise and remove it from the assembly. Gently pull out the bulb either with gloves on or wrapped in a towel to prevent injury.
- Replace the old bulb with a new one.
- Attach the push pins and the two fasteners.
- If the headlights are not functioning properly, then you will need to change the signal fuse.
- Locate the fuse underneath the hood on the driver's side. Take off the cover and locate the "park lamp." This fuse is for the lights outside of the car. If the metal fuse is not in one piece you will need to replace it.
- Pull the fuse out and replace it.