How to Fix a Flooded Push Mower
It's very discouraging to discover that somehow your push mower is flooded and will not start. And continuing to try to start it will only make matters worse. This scenario can happen to anyone, unfortunately. You are left just wishing there was a magic button to get this thing started. Here are two techniques you can use to get it started.
Wait for Evaporation
Give the mower time to sit for about 20 minutes. Many times this alone gets the mower going. The carburetor was overfilled with gas, and you are waiting for it to evaporate.
Remove the Excess Gas
- Find a spark plug socket to fit.
- Disconnect the spark plug wire.
- Remove the spark plug.
- Tilt the mower so that the spark plug hole is pointing down. Usually this mean raising the back. If no one is there to hold the mower up in the back, block it up.
- Slowly pull the start cord, which will slowly turn the engine over and force excess gas out the spark plug hole. Do this several times until no more gas spits out.
- Dry off the spark plug's electrode end with a rag. It is most likely wet from gas. You can also blow on it hard to force the gas out and help dry it.
- Replace the spark plug and spark plug wire. Be sure the spark plug is snug but don't over tighten it.
- Pull the start cord a few times. Do not give it any gas, choke it or prime it. Give it a bit of choking if it tries to start. It should start without doing anything, though.
- Give it more time to sit if it does not start, but that should do the trick.