Previous Article

How to Install Bifold Door Hardware

Next Article

How to Install Brackets for Home Shelves

How to Install Book Shelves

All books need a proper home and the best place to keep them is on a shelf dedicated specifically for them. Any avid book aficionado will tell you that the correct storage of a book is vital for a book's continued longevity. With a few simple tools and supplies, you can install the necessary shelving to keep your books in tip-top usable condition.

Supplies:



  • Level

  • Tape measure

  • Drill and 1/4 inch bit

  • Screws

  • Pencil

  • Book shelf wall mounts

  • Book shelf  top board

  • Book shelf corner supports

  • Stud finder

  • Masking Tape


Installing the Shelf:



  1. Use the stud finder to locate the wall stud on the wall where you are planning to install the bookshelf. This is important, as installing the shelf components into the stud will give the shelf more strength for the load capacity of the books.

  2. Hold the bookshelf's mount flush against the wall with one hand, and place the top board of the bookshelf on the mount with the other hand. Lay the level on top of the top shelf and make sure the mount and top shelf are straight and level.

  3. Remove the top board but continue holding the wall mount in place. Use the pencil to mark the spots where the installation holes should be drilled on the wall.

  4. Place a small piece of masking tape over the marking where the hole is to be drilled. Make sure that the drill mark is visible through the tape. This keeps the drywall from splitting when the drilling the hole.

  5. Install the 1/4 inch bit into the drill and drill the holes in the marked spots. Use a screw driver to install the first wall mount with screws making sure it remains level.

  6. Attach the corner supports for the shelf to the wall mount with additional screws.

  7. Repeat the above process for the other end of the shelf. Take special care to make sure the top shelf board is level when attaching the last wall mount and support arm.

  8. Place the top board on the support arms and secure it with screws when both wall mounts and corner supports have been installed properly on the wall.