How to Install Bifold Door Hardware
The installation of bifold door hardware is actually a simple procedure . That is unless you choose to work with heavy doors or if the closet opening isn’t exactly ‘square’. The most difficult and sometimes the most frustrating part of the job is often dealing with the installation and adjustment of all the hardware.
- Check measurement and position of your pivots. The track and the pivots that follow them must be assembled ‘just so’. Make sure the measurements are correct and that every piece is facing forward.
- Mark a jamb side door roughly 11 inches from the bottom of the door and roughly 7 inches from its top and the center between the two marks.
- Take the lower half of a hinge and align its bottom with the bottom mark of the door with its ‘knuckles’ facing back and flush against the edge.
- Use a self-centering drill pilot to drill your pilot holes through your hinge holes and screw on the hinge plate.
- Attach the top and middle hinges respectively according to their marks.
- Repeat the above steps on the second set of doors.
- Fasten the pins that fit into the track and the floor bracket along with the hooks that slide along your tracks to both the top and the bottom of each set of doors.
- Install the track itself. Use your hacksaw to cut your track to the appropriate size of your closet if needed. Slide the hanging hardware onto your track making sure that the small stops are in the center, then around them, the actual track hangers with wheels. Finally, your pivot socket is places along the outside.
- Attach the door header. Make sure you do not tighten the hardware onto the track. It’s easier to hang the doors if you leave the pieces loose.
- Position your floor bracket next to the doorjamb.
- Hang a plumb bob from the very center of your track above your floor bracket. Outline the bracket in chalk or pencil to note its precise location. Create the bracket pilot holes.
- Hang your doors by the top pivot pin.
- With the doors closed, swing them forward and catch the floor bracket pivot-pin.
- Attach your floor bracket.
- Hang the opposite side of the doors.
- Attach your door aligners. From the inside of the closet, mount the door aligners between the two lead doors.
- Install your door pull roughly 36 inches from the floor and at the center of that height.