How to Program an Acura RL Keyless Remote
Order replacement keyless remotes from your Acura dealership may cost a little bit more money than you would like. If you've misplaced your keyless remotes for your Acura RL you can order another set online from cheaper sources and save a few bucks. Ordering your own keyless remote does mean that you will have to program it yourself. For the Acura RL programming a keyless remote is easy and only takes a few minutes.
- Sit in your Acura RL in the driver’s seat with the ignition key and remotes that need to be programmed. Make sure all the doors are closed. Unlock all the door locks with the "Unlock button" on the door panel on the driver's side of the vehicle. Place the key into the ignition, and then turn it to the "Lock" position.
- Press and release the "Lock" button on the keyless remote that is being programmed. Turn the key to the "On" position marked by "II" on the ignition bezel so the dash lights come on, and then turn back to the "Lock" position. Repeat this process a couple more times, then press and quickly release the "Lock" button on the keyless remote. The vehicle will enter into programming mode for the remote when you hear a chirping sound that comes from the alarm system. You must hear this chirping sound to proceed. If you don't now hear this sound repeat the above steps until you enter into the programming mode.
- Press and release the "Lock" button again on the remote. Once you hear the chirping sound again this indicates that the keyless Acura RL remote was successfully programmed. Repeat this process for any additional remotes that need to be programmed.
- Turn the key to the "Off" position and remove the key from the ignition. This will exit the programming mode for the remote. Test all the remotes by locking and unlocking the vehicle doors with the keyless remotes.