Previous Article

How to Remove an Acura RL Radio

Next Article

How to Program an Acura RL Keyless Remote

How to Replace Acura RL Brake Pads

The safety of a car being able to stop is extremely important when it comes to cars. A car should not be driven without safe brakes, as this could cause an unnecessary accident. With proper up keep of your Acura braking system, your brakes failing on you can be prevented. Brake pads need to be checked on a regular basis and replaced when they get low. Here is how to replace Acura RL brake pads.

Things you need:



  • Jack and stands

  • Socket set

  • Caliper compressor



  1. Raise the car with the jack and place the jack stands under the car for support. Loosen and remove the lug nuts from the wheel.

  2. Loosen the caliper by removing the two bolts holding it in place. With the bolts removed the caliber should swing away from the rotor. This will expose the pads on the Acura so that you can slide them out of place. Be sure to keep the metal plates on the back of the old brake pads.

  3. Use the caliper compressor to compress the cylinder to allow you easily slide the new brake pads in to place. Put the metal plates on back of the new pads. Slide the new pads on and they should automatically clip into place.

  4. Put the caliper back into place over the rotor and replace the two bolts over the caliper. Replace the wheel and the lug nuts on the Acura. Remove the jack stands and lower the car back to the ground.

  5. Tighten the lug nuts once the car is on the ground. Take your Acura for a test drive and make sure that the break pads have been accurately replaced.