Previous Article

How to Replace an Acura RL Fuel Pump

Next Article

How to Replace Acura RL Brake Pads

How to Remove an Acura RL Radio

Although the Acura RL has a state of the art factory stereo installed in the vehicle, many have preferences as to aftermarket stereo systems to get just the right sound they want out of their stereo. Installing a new stereo system is not difficult, as long as you follow a few steps.

Directions:



  1. Unhook the negative battery connection from your battery and pull it aside to prevent any short-circuits in the battery or any electrical mishaps when you are putting in the new stereo system.

  2. Separate the panel trim from the gear shift and the console. There is a removal tool for this. Once you have pulled the trim out, put it aside and out of your way.

  3. Move the ashtray up to gain access to two screws at the upper section. Remove those screws with a Phillips screwdriver by unscrewing them.

  4. Locate two small panels (which are rectangular in shape) on each side of the stereo and extract them from the dashboard. The two panels can be snapped loose, which will give you access to the bracket bolts holding in the stereo.

  5. Unscrew the bolts on opposite sides of the stereo using an eight millimeter socket and the two screws under the stereo with a Phillips screwdriver. Pull the now loose stereo away from its position.

  6. Pull loose the plastic pieces connecting the wiring, which are located in back of the stereo. Pull loose the antenna connected to the back of the stereo and remove the stereo from its compartment.