Previous Article

2008 Acura RDX Specifications

Next Article

How to Remove an Acura RL Radio

How to Replace an Acura RL Fuel Pump

Replacing the fuel pump on your Acura RL requires mechanical knowledge. You will be working closely to the fuel tank and relieving pressure in the fuel system. To get to the fuel pump, you will need to remove the back seat. If you don't feel comfortable doing these things, you may want to enlist a friend who has mechanical knowledge to help you through it.

Things You'll Need



  • wrench

  • tube wrench

  • Phillips screwdriver

  • ratchet and socket

  • ratchet extension

  • new pump assembly O-ring

  • shop rags


Relieve Pressure in Fuel System



  1. Park your Acura on a flat surface with the engine off and cooled.

  2. Open the hood.

  3. Using a wrench, remove the negative, black-colored battery cable from the battery.

  4. Locate the fuel filter cap and loosen it. The fuel filter is on the upper driver side of the firewall inside the engine compartment.

  5. Place a shop rag on top of the filter.

  6. Use a tube wrench to loosen the top fuel line bolt on the filter.

  7. Allow the fuel pressure to release then tighten the bolt.


Remove Fuel Pump



  1. Locate the retaining strap on the back of the rear seat of your Acura.

  2. Pull the strap from the rear seat and lift the seat off the floor.

  3. Find the floor access-panel door.

  4. Using a Phillips screwdriver, unscrew the three screws and remove the door.

  5. Locate the fuel pump electrical connector and unplug it.

  6. Look for the fuel lines on top of the fuel pump assembly. Detach these by pressing the lock tabs and pulling the lines away from the plastic connectors and fittings.

  7. Use a ratchet, ratchet extension and socket to unscrew the mounting nuts from the pump assembly flange.

  8. Lift the pump assembly up and off the fuel tank.

  9. Dispose of the O-ring underneath the flange.


Install New Fuel Pump



  1. Get your new fuel pump and install it on the pump assembly.

  2. Place the fuel pump on the fuel tank with your new O-ring.

  3. Using a ratchet, ratchet extension and socket, tighten the mounting nuts on the pump assembly flange.

  4. Connect the fuel lines back to the fittings on the top of the assembly.

  5. Plug in the fuel line electrical connector. 

  6. Replace the floor door-access panel and tighten the screws in.

  7. Put the rear seat back in your Acura.

  8. Go back to the engine and tighten up the fuel filter cap.

  9. Reconnect the negative battery cable and tighten.