Previous Article

How to Prime a Shallow Well Pump

Next Article

How to Troubleshoot a Shallow Well Pump

How to Replace a Shallow Well Pump

A shallow well pump acts as a suction that lifts water into a pressure tank. It is used in a well of a depth of 25-feet or less. With prolonged use the pump can wear out and cease to function effectively. When the pump no longer has pressure to pull the water, replacement is necessary.


 

Tools:



  • Open-End Wrench

  • Volt Meter

  • Screw Driver

  • Teflon Pipe or Thread Seal Tape


Instructions:



  1. Turn off the electricity leading to the well pump.

  2. Locate the pump and using the wrench, open the ports on the jet pump- both the inlet and outlet ports.

  3. Check the function of the pump to determine where the problem lies.

  4. Remove the old pump and disconnect all the wiring from the terminal using the screwdriver. If the well plumbing is stuck to the old pump, use a hacksaw to cut the area around the pump.

  5. Use the tape to wrap the threads of the pipe at the inlet and outlet.

  6. Install the new pump by screwing on the pipes. The inlet is the part that comes from the well while the outlet is that which goes to the house. Use the plumbers' wrench to tighten the plumbing.

  7. Wire the new pump and reconnect the wiring to the electric terminal using the screwdriver. Make sure the colors match, black and white for positive and negative.

  8. Turn the electricity back on and test the new pump. A shallow well pump needs priming for it to work well. Priming prevents build up of air in the pipes and involves running the pump until water leaks out.

  9. Prime the pump frequently to keep it working well.