Previous Article

Where to Get Business Loans

Next Article

Types of Phone Cable Tools

How to Run a Phone Cable

Telephone cables inside your home enable you to have access to the network interface device (NID) that are located outside your home.  The NID is the main distribution point that allows for the telephone wires to run to different jacks throughout your home. Here is how to run a telephone cable to get your phones connected.

Materials Needed:



  • Telephone cable

  • Screwdrivers

  • Diagonal pliers

  • Wire stripper

  • Staple gun

  • RJ-14 telephone jack



  1. Remove the modular plug located inside the NID from its jack to cut off the power supply. Unplug the short wire and the connector from the jack to stop the power to prevent any voltage shock.

  2. Pull out the cable from inside the NID box by slipping a telephone cable into the bottom of the NID or gray box. Use diagonal pliers to remove about three inches of cable that is covering up the tip to uncover the inner wires. Be extra careful not to nick any of the inner twisted wires. Use a stripper tool to peel the insulation on the green and red wires by about 3/4-inch.

  3. Loosen the red and green terminal screws from the NID you unplugged that are located behind the connector. Wrap the green and red wires clockwise around their corresponding terminal screws to connect the terminal wires to the cable block. Use a screwdriver to tighten both screws.  

  4. Run the telephone cables in the places you intend to place a phone set. To avoid signal interference keep at least 12 inches between any electrical wires. Avoid wrapping the wires around hooks or nails and do not run it under carpet on the floor. Attach the cable to the surfaces using a stable gun.

  5. Cut the cable when it gets to the target area. Make sure to leave at least three feet extra at the end. Use diagonal pliers to remove three inches of the cable covering to uncover the inner wires. Be careful not to nick or cut any wires. Use a wire stripper tool to peal about 3/4 inch of the insulation on the green and red wires.

  6. Mount a RJ-14 jack using screws and a screwdriver on the wall to where you intend to place the phone. Loosen both the red and green terminal screws located inside the jack.

  7. Wrap the green and red wires clockwise around their corresponding terminal screws to connect the terminal wires to the cable block. Use a screwdriver to tighten both screws.  

  8. Plug a phone into the jack and go outside your home and replug the modular plug in its jack located inside the NID. Pick up the phone headset and listen for a dial tone. Test the line by calling a number. Call your landline number with your cell phone to make sure the phone rings.