How to Tune Downhill Skis
No mater how well of a skier you are, after a while your skis will need to be tuned. Over time, the base of the skis will lose some of their wax, incur rock dings and the precision on the edges will be reduced. Your first tune-up of the year should be performed by a professional, however throughout the season you can perform them yourself.
What You'll Need:
- Ski workbench or a pair of chairs
- Thick rubber band
- Metal file
- Diamond stone
- File guide
- P-tex candle (optional)
- Metal scraper
- Wax
- Used clothes iron
- Ensure that your ski brakes are secure and in the up position. You can complete this step by using a thick rubber band. Secure the skis in a ski workbench, if you don't have one you can convert two chairs back to back and use the tops of the the chairs to support your skis.
- Inspect the ski bases for any burrs or dings. To fill any dings you find, ignite the end of a P-tex candle and melt a generous amount of P-tex into the dings. You'll want to allow it to dry for at least 15 minutes then scrape off the excess P-tex by using a steel metal scraper. If the ding is very deep, you may need to repeat the process to completely fill it.
- Take a steel scraper and run it down the entire length of the ski bottom. This will ensure that you have a smooth and even surface.
- Use a steel file to flatten the running surface of the skis. Visit a local ski shop for recommendations on the best type for your particular model of skis. You can run the file in one direction starting from the tip and then to the tail.
- Take a steel file and secure it to a file guide that is set to the degree of bevel you desire. Press firmly on the edges and run the file and guide from tip to tail several times. When completing this step ensure that you keep the bevel even. Repeat this process on the other set of edges.
- Flip over the skis onto their sides and repeat the previous step. You'll need to adjust the degree of bevel if desired, however, a bevel with one degree bevel will work for either sides of the edges.
- Run a diamond stone completely down the length of the edges. Along the bottom as well as the sides. This will remove any small burrs from the edges.
- Plug-in a clothing iron and turn it to the lowest setting it has. Once the iron is warm, press the corner of a bar of wax onto the warm part of the iron. Allow the wax to drip down the complete length of the skis. While the wax is still warm, begin to iron the wax from tip to tail. Allow it to cool for 15 to 20 minutes before moving on. Once the wax has cooled, scrape of any excess wax using the metal scraper. Repeat the process on the other ski as well.