How to Use Offset Fish Hooks and Plastic Worms
The shape of an offset fishing hook is slightly different than regular hooks because it has two bends in it. Each bend is about 90 degrees. These bends are designed to make placing bait such as a plastic worm or other bait a bit easier and the bait will stay on the hook better. Fishermen use plastic worms and an offset hook because the plastic worms will last longer while fishing.
- Examine the size of your hooks and the size of your bait. If your plastic worm is too large for your hook, you should use a smaller plastic worm or cut the plastic worm in half with a knife.
- Grasp the end of the plastic worm and hold the offset hook in your other hand.
- Place the end of the plastic worm on the hook and push the worm into the hook.
- Bend the plastic worm and place another part of it onto the offset hook.
- Push the plastic worm up the hook and continue bending and placing the hook in the worm. The plastic worm should cover the whole hook.
- Examine the hook to see if the plastic worm covers the hook. If it is not completely covered, get another plastic worm.
- Place the second plastic worm on the hook by grabbing the end of the worm and feeding it onto the hook in the same motion that you used with the first plastic worm.
- Cut any extra plastic worm off the end of the hook by using a pair of scissors or a knife. Remove the extra plastic worm and save it with the rest of your bait for the next time.