Previous Article

How to Wire Home Security Systems

Next Article

How to Wire Solar Panels

How to Wire Landscape Lighting

An electrician is not needed to wire landscaping lights. Most landscape lighting have low voltage wires, there are no deep trenches to dig so installation is relatively easy. You can wire your own landscape lighting yourself with these fast and easy instructions.

How to Wire Landscape Lighting



1. Calculate the total wattage needed for your landscape lighting system.



2. Choose the proper transformer that can handle the wattage you need. Find a location to install the transformer for your lighting. Find an exterior receptacle close by and mount the transformer three feet above the ground close to the receptacle.



3. Purchase the low wattage cable you will need. 14-gauge cable is perfect for a system with less than 200 watts. If your landscape lighting system has more than 200 watts, use 12-gauge cable.



4. Strip about a half inch of insulation off the cable. Attach the wire to the transformer according to the instructions.



5. Arrange your landscape lighting. Place your landscape lights in areas that of your yard that will illuminate your landscaping and add beauty to your home's exterior.



6. Run the low voltage cable to the lighting, leave a small amount of slack at each light to attach the cable.



7. Attach the cable to the lighting fixtures by slipping the connector halves over the slack loop of cable, then press them together firmly until they click into place.



8. The low voltage cable does not need protection from the elements, however, it's best to keep it out of the way of lawn mowers and weed eaters.



9. Test your landscape lighting by turning on the system. All the lights should illuminate. If you find one that does not, remove the connectors to that light and connect again.



10. Set your on and off times if your system includes a timer.