Previous Article

How to Mount Exterior Wall Lights

Next Article

How to Wire Wall Lights

How to Wire Outside Wall Lights

When installing an outside wall light, local electrical wiring codes must be followed. If you do the work yourself, you should know what the codes are. It is not that hard to do but it is important to know the proper procedure to ensure you do not make any mistakes.

Items Needed:



  • Drill (preferably cordless)

  • 4-in-1 screwdriver

  • Enough 14 gauge wire to do the install

  • Wire stripper and cutter

  • Cable connectors

  • Wire nuts

  • Exterior screws



  1. Decide where the light fixture is being placed on the outer wall. Make certain that you will have access to inside wiring to which you can connect.

  2. Go inside and find the nearest electrical wall outlet to wire the light into.

  3. Drill a hole in the outside wall large enough for the wires to pass through and not so large that the fixture of the light will not cover it. Try drilling slightly upwards so water cannot come into the home or business.

  4. Push the wires in the fixture through the wall or pull wires from inside the wall out and wire the fixture.

  5. Mount the light fixture to the outside wall.

  6. Go inside and cut a hole in the wall where you can install a gang box for your light switch.

  7. Complete the installation of the gang box and wire both the light and the light switch to the gang box.

  8. Turn off the current to the wall outlet you will be using for power.

  9. Connect both the switch and light to the wall outlet making certain it has been disconnected from power.

  10. Cut enough wire to reach from the switch to the outlet with a little room for working with it. Drop it down through the wall to the outlet.

  11. Remove the outlet cover if you have not already done so and bring in the wires from the switch above.

  12. Hook these wires into the outlet and replace the cover.

  13. Turn your power back on and your new light should come on.