Instructions for Making Water Clocks
A water clock is a collective term for any device that uses water to keep time. These devices vary in design, but they generally make use of water dripping at a constant rate. You can build a simple water clock from ordinary items.
Things You'll Need:
- 2-liter plastic bottle
- Scissors
- Wax pencil
- Rubber stopper
- Rubber tubing
- Ring stand
- Tubing clamp
- Food coloring
- Cut the bottom off a 2-liter plastic soda bottle with a pair of sharp scissors. Draw a line around the soda bottle near where you cut it with a colored wax pencil. The line should be just above the cut edge of the bottle.
- Remove the cap from the bottle, and plug the opening in the bottle securely with a rubber stopper that has a hole through its middle. Place a rubber tube through a hole in the stopper from the outside so that it extends out of the other side of the stopper.
- Turn the top half of the soda bottle upside down and place it into a ring stand. Clamp the free end of the rubber tubing closed with a tubing clamp.
- Prepare a mixture of 1 liter of water with a few drops of food coloring. Fill the top half of the soda bottle to the line you marked with colored water. Place the free end of the rubber tubing in a clean container.
- Loosen the clamp slightly to provide a slow but steady drip of water into the container. Mark the plastic soda bottle every 10 minutes to indicate the level of the water. Label the marks in increments of 10 minutes.