How to Cut Bar Stool Legs
Bar stools can be used in a variety of settings. Many night clubs and bars have stools to sit on. Homeowners also like bar stools to use near a kitchen island or family room bar. Most homeowners want bar stools that fit properly to the counter or table. In order to get the stools to fit properly in the home, a homeowner may have to cut the bar stool legs. This is a simple process that can be done in less than an hour.
1. Measure the space between the floor and table or counter you will be using.
2. Measure the bar stools, from the underside of the legs to the top of the seat. Typical stools measure 24 to 26 inches from the floor to the top of the seat.
3. Use a piece of wood or sturdy cardboard as your measuring pattern. Mark on the pattern where you want the stool to be cut. To determine where the stool should be cut, measure and consider the standard height of a stool to be 10 to 12 inches from the underside of the table to the top of the seat.
4. Align your pattern with one of the legs of the stool. Mark a line on the leg of the stool so you know where to cut it. You will want to make a mark that goes all the way around the bar stool legs
5. Complete this process with the remaining three bar stool legs. Then, repeat this process for each of the bar stools you will be cutting. If the bar stools are the same, you will not need to measure again. You can use the same pattern for all the stools.
6. Turn the stool upside down and place hose clamps on each leg. If you only have one clamp, you will need to clamp the leg, cut it and then place the clamp on another leg. The clamp will keep the stool legs from cracking or splitting during the cutting process.
7. Turn the stool on its side and cut the leg with a handsaw. Repeat this process for all four legs on each stool.
8. Sand the bottom of the newly cut legs by taping four pieces of 60-grit sandpaper to the floor. Place the stool on the sandpaper and move the stool back and forth while applying pressure to stool base. This sandpaper will remove the rough edges from the legs of the stool.
9. Add felt pads to the bottom of each newly cut stool leg. This pad will protect the floor and the stool legs from wear.