How to Fasten Wood to Concrete
If you are doing a project on floors in the garage or basement, you have to work with the concrete. Fastening wood to the concrete may be a task you may want to know how to accomplish. You have to decide how much stress the fasteners can handle to connect the concrete to the wood. The connection between the two can be permanent or removable. The task is easy and simply to accomplish.
Materials Needed:
- Rotary hammer drill
- 20 ounce hammer
- 16d nails
- ¼ inch x 4 inches up to ¼ inch x 6 inch long masonry drill bits
Instructions:
1. Attach a ¼ inch x 4 inch up to ¼ inch x 6 inch long masonry drill bits into the rotary hammer drill.
2. Place the wood over the area on the concrete you want to attach it to.
3. Find the center point on the wood.
4. Drill a hole into the wood and through the concrete. The hole should be as long as the nails are.
5. Regularly pull the drill out so you can extract the wood and concrete dust.
6. Remove the drill but keep the wood in its exact location.
7. Gather two nails and insert them into the hole in the wood. Push them in as far as you can with your hand.
8. Use the hammer to drive the two nails through the wood and into the concrete. Use short powerful blows. This creates a connection between the wood and concrete that can only be removed with a pry bar.
9. Continue to attach the wood to the concrete. Make sure the holes have 16 inches to 2 feet of space between them.
10. Use a can of compressed air to remove the concrete and wood dust.