How to Fish Bolts for Trailer Hitch Installation
Installing a trailer hitch to a car or truck is unfortunately not always as easy as one would expect. One of the trickier aspects of installing a trailer hitch properly is fishing the bolts holes through the blind bolt holes. There are some useful tricks to employ when faced with this task.
Items Needed:
- Mechanical wire
- Monofilament fishing line
- Electrical tape
Instructions:
- Examine closely the holes in the trailer hitch frame. These holes were designed by the hitch manufacturer specifically for use with mounting bolts. It is important that you identify the correct holes you will need to work with because recovering bolts from an incorrect hitch hole is quite difficult.
- Create a loop in a piece of mechanic's wire in the shape of a keyhole. This keyhole shaped loop should be able to fit securely around the threaded section of the bolt.
- Push the bolt into the hitch frame using the keyhole shaped wire loop until the bolt can be inserted into the appropriate hole. When the bolt is in place, pull on the wire loop to straighten it out. This will release the bolt, leaving it in its proper place inside the blind bolt hole.
Tip:
- If access inside the hole is not possible through using a wire, you can try running a length of fishing line through the hole instead. On the other side of the hole, tie the fishing line end around threaded part of the bolt and secure with a bit of electrical tape. As you pull the fishing line back, the bolt will be fished through the hole.