Previous Article

How to Get Cheap RV Rentals

Next Article

How to Fish Bolts for Trailer Hitch Installation

How to Build a Trailer Hitch Cargo Carrier

Families that travel with baby strollers and other accessories, individuals hauling a catch back from a deep-sea fishing trip and many others often find a trailer hitch cargo carrier necessary. A number of manufacturers produce trailer hitch cargo carriers; however, the carriers can be expensive. A person can customize a trailer hitch cargo carrier to meet specific needs by personally constructing one.

Items Needed:



  • One sheet of 14-gauge flat metal in the size planned for the carrier

  • 12-inch thick walled square bar

  • 16 one-inch tubing end caps

  • 342 inches of 16-gauge, one-inch square tubing

  • Marker

  • Paint

  • Paintbrushes and tray

  • Pipe clamp

  • Primer

  • Protective gloves

  • Safety goggles

  • Sander

  • Sawzall or hacksaw

  • Square

  • Tape measure

  • Welder



  1. Purchase the necessary supplies and have the 12-inch thick walled square bar pre-drilled at the home center store for a hitch retainer pin.

  2. Utilize a tape measure to measure out six lengths of the 16-gauge one-inch square tubing to 24-inch lengths or the width planned for the trailer hitch cargo carrier.

  3. Mark this point with a marker. 

  4. Cut six lengths of the 16-gauge one-inch square tubing to 24-inch lengths or the width planned for the trailer hitch cargo carrier. 

  5. Utilize a tape measure to measure out 11 lengths of the 16-gauge one-inch square tubing to 18-inch lengths or the depth planned for the trailer hitch cargo carrier.

  6. Mark this point with a marker.

  7. Cut 11 lengths of the 16-gauge one-inch square tubing to 18-inch lengths or the depth planned for the trailer hitch cargo carrier.

  8. Lay out four of the 24-inch bars 4 1/2 inches apart parallel on a flat surface.

  9. Weld two of the 18-inch bars to each end of the four 24-inch bars.

  10. Weld a third 18-inch bar to the center of the four 24-inch bars for support. 

  11. Weld the pre-drilled 12-inch thick walled square bar to the 18-inch center bar.

  12. Flip the welded square over and attach the sheet of 14-gauge flat metal to the bottom of the frame.

  13. Weld the 18-inch bar at each corner and an 18-inch bar at the center of the longer two sides.

  14. Weld the two remaining 24-inch sections and the two remaining 18-inch sections to the top of each vertical 18-inch bar to form a rectangle.

  15. Allow the welds to completely cool and then sand the welds smooth, being careful not to weaken the welds.

  16. Pour the primer into a tray.

  17. Apply a coat of primer to the carrier and allow to dry.

  18. Paint the carrier and allow the paint to dry.

  19. Place the end caps on the open ends of the tubes.