How to Fix Cracks on Concrete Resurfacing
Concrete is very strong and stable, which makes it a good choice to use for floors, driveways, and patios. Over time, however, even concrete can become cracked, especially if exposed to the outside elements. Fortunately, you can fix cracks on concrete yourself.
- Use a shop vac to vacuum the cracks and clean out all dirt, dust, and debris, Remove loose pieces of the crack using a hammer and chisel and remove them.
- Use a pressure washer set to low and wash out the crack to remove the dirt and debris you can’t remove with a shop vac.
- Allow the surface to dry thoroughly, and then mist the area using a hose.
- Get two different buckets to be used for mixing. Pour cement into one bucket. The amount you will need depends upon how big the crack is in the concrete. You do not need very much, as this will not be used to fill in the crack.
- Add water to the bucket that has the cement and mix using a power mixer. Continue until the cement is about the same consistency of paint.
- Put concrete patching compound in the second bucket. This is going to be used to fill in the crack so it will be thicker. The amount needed will depend upon the size of the crack. Follow the manufacturer’s directions on how to mix it correctly with water.
- Place a thin layer of the cement on top of the crack using a paintbrush. Ensure you spread the cement around the crack on all sides.
- Apply a thin layer of the cement mix on the surfaces of the crack, including the inside of the crack, using a paintbrush. Spread the mix approximately one inch from the crack on all sides.