Previous Article

How to Date Bricks and Cement Blocks

Next Article

How to Make Molds for Cement Blocks

How to Form a Foundation Using Cement Blocks

Concrete block foundations are not difficult to build if you have average construction or home improvement  skills. By using a proper block laying technique for installation, a foundation can generally be constructed in less than a week, depending on the size of the project. Here's how to get started:

Supplies 



  • Concrete blocks

  • Mortar mix

  • Hand trowel

  • Level

  • Thumb jointer


 



  1. Lay out the foundation walls. Be sure they are square at the corners.

  2. Start at one corner and run a tape along, marking your wall dimensions. This should be done for all four corners.

  3. Double-check the corners by measuring them diagonally. The measurements across both diagonal measurements should be the same. Make any needed adjustments and recheck the measurements.

  4. Pull and snap a chalk line on the footings to connect the corner marks.

  5. This is where you will begin laying your first row of blocks. Make sure your foundation is a height of at least 48 inches on all sides.

  6. Place four blocks in one direction from a corner and three blocks in the opposite direction of the corner. Apply a two inch bed of mortar using the trowel for the first row of blocks. Make sure to apply mortar where the block ends join together.

  7. Stagger the next row of blocks. Apply mortar to the top of each previously laid block before stacking the next block.

  8. Make sure to use a level to keep the corner plumb and block frame straight.

  9. When the blocks are laid use a thumb jointer to smooth out joints.