How to Remove Tile Adhesive From Concrete
When you remove old tile from the surface of a concrete floor, adhesive is left behind. The thinset is also attached to the adhesive and concrete. The adhesive must be removed before new tile can be installed. This will help the new tile look and adhere better. If the adhesive is not properly removed, you will find that the new tile is much more difficult install.
Materials Needed
- Plastic covering
- Painter’s tape
- Electric hammer chisel
- Broom
- Shop Vacuum
- Water
- Detergent
1. Use a plastic covering to cover all of the doors. Use painter’s tape to tape the corner of the plastic covering. Place the tape on the frame of the door and not the wall to avoid damaging the paint.
2. Secure the blade into an electric hammer chisel. Follow the manufacturer’s instructions to put the blade into the chisel.
3. Position the electric hammer chisel at a 30-degree angel to the concrete floor.
4. Make sure the blade is at the bottom of the adhesive.
5. Turn on the electric hammer chisel.
6. The hammer chisel will begin to move in the same way as a hammer move.
7. Push the hammer chisel forward to remove the adhesive from the top of the concrete.
8. Continue using the hammer chisel over the entire area has no adhesive.
9. Use a broom to sweep the scraped adhesive. Use a shop vacuum to remove any remaining debris.
10. Wash the area with detergent and water. Rinse the area. Allow the area to dry.