How to Repair a Truck Headliner
Like many items for your vehicle, the headliner is made of petroleum-based products that are prone to cracking, drying and breaking up. Dealers and trim shops can be expensive, and most people rarely budget for the “small stuff,” which can cost a small fortune. The good news is that you can make the repairs yourself for less than $100.
What you will need
- Screwdriver
- 2 yards headliner fabric with foam backing
- 2-3 cans of 3M Headliner 82 Spray Adhesive
- Clips for holding fabric for drying
- Remove the trim-surround and overhead light fixture. You may need to remove other accessories depending upon the make and model of your vehicle. You will also need to remove your sun visors.
- Remove the headliner from the truck. This may require some maneuvering of seats and in some cases, you may have to remove one seat to get the piece out of the truck.
- Remove fabric from the headliner board and clean thoroughly. Any access foam can cause lumps that will give the headliner an unappealing look when finished.
- Lay the headliner board on the fabric for your pattern. Leave 1 ½ to 2 inches of fabric all around the board.
- Spray both the headliner board and fabric with 3M Headliner 82 Spray Adhesive and allow to set according to factory instructions.
- Place headliner board on fabric carefully. Once the pieces meet it will be difficult, if not impossible, to pull them free again, and it will ruin your fabric.
- Spray the access fabric and approximately an inch all around the headliner board, again allowing to set according to factory instructions, and allow to dry.
- Place the headliner back into position in the truck and replace all trim surrounds, lights, visors and accessories.
Tip: Most trim shops do not recommend attempting to make repairs with glue because the appearance, if it holds, looks uneven.