Previous Article

How to Replace a Standard Car Radio Antenna

Next Article

How to Choose a Car Stereo Dealer

How to Splice a Car Radio Antenna

Car antennas work by connecting to the radio via a coaxial cable. By splicing the antenna, you can connect two separate cables to form one solid connection. The project is not difficult and can be accomplished with a few materials and tools. 


 

Items Needed:




  • Adjustable wrench

  • Cable cutters

  • Coaxial cable stripper tool

  • 2 male coaxial connectors

  • Coaxial cable connector crimping tool

  • 1 male-to-male barrel connector

  • Electrical tape


Instructions:




  1. Make sure your car is turned off and that the key is not in the ignition. Pop open the hood.

  2. Locate the battery and disconnect the red positive battery cable from its terminal. This is a safety precaution that will guarantee that there is no electricity running through the car's wiring.

  3. Find both the car antenna ends that are going to be spliced together. Use a cable cutter to cut 1/4 inch from the ends of both of the cables. This will ensure a nice, clean edge on the cable ends.

  4. Use the large end of the cable stripper tool to strip off the outer insulating jacket 1 inch from the tips of the cables.

  5. Use the smaller end of the cable stripper tool to then strip off 1/2 inch of the wire mesh and plastic insulation from the tips of the cables. This will expose the conductor in the center.

  6. Slide one of the cable ends into one of the male connector ends. Use the crimping tool to crimp the connector and the cable together.

  7. Repeat step six with the other cable and male connector.

  8. Insert one of the male connectors into one of the barrel connector ends and screw it in. Tighten the connectors to the plug of the barrel with a wrench.

  9. Repeat Step 8 with the other male connector and the other end of the barrel connector.

  10. Cover the connectors with electrical tape.

  11. Connect the positive battery cable back to its terminal to re-establish electrical currency.

  12. Turn your car's ignition on and turn the stereo on to the accessory mode. Test your radio antenna by scanning between different stations.